V40 2.0 D3 BOSCH EDC17_CP48 526207 — ECU Calibration File Stage 1 

Volvo’s 2-litre D3 in the 2013 V40 is mapped for long-term fleet reliability and stringent Euro-5 emissions, so pedal response feels muted and sustained boost is deliberately capped. This Stage 1 calibration for the Bosch EDC17_CP48 controller remaps driver-wish and torque-limiter surfaces to deliver a more linear, immediate correlation between accelerator position and engine output, refines rail-pressure ramps for steadier combustion under rapid load changes, and lifts turbo duty within factory exhaust-temperature margins. Injection timing is optimised only across the mid-range, leaving cold-start, idle and altitude corrections untouched for OEM smoothness. EGR flow is trimmed and diagnostics re-balanced to keep the intake charge cleaner without provoking fault codes. All DPF, sensor-plausibility and limp-home safeguards remain fully active, so the ECU will still intervene if mechanical or thermal limits are approached. The result is quicker spool, livelier mid-range pull and more effortless motorway cruising—achieved with zero hardware changes and full emissions self-check integrity.

All tuning files were acquired through official EVC.de resellers and verified on a professional dynamometer. Each calibration corresponds to the developer listed in the “Modified By” section — performance graphs may be available on their official website. These files are intended for motorsport or off-road use only. Ensure proper installation and do not operate the vehicle aggressively without first confirming mechanical condition. The seller accepts no responsibility for misuse or non-compliant road use.