Snapshot
CONSULT III Plus is Nissan/Infiniti’s OEM diagnostic environment. This v241 build pairs smoothly with VCXDiag Nano for full-system scans, Data Monitor, Active Tests, utility procedures, and subscription-based ECU programming.
Toolkit

What it does

• Health Check, read/clear DTCs with freeze data
• Data Monitor with graphing + snapshot replay
• Active Tests and utility functions (EPB, steering angle, key/remote on supported models)
• Configuration/coding for eligible ECUs
• ECU reprogramming when used with a valid Nissan J-2534 subscription

Quick start

1. Install C3P v241 → apply DiagnosticTool.ini and registry preset.
2. Install VCXDiag drivers, then select VI/MI and verify USB status in the main screen.
3. Run a vehicle auto-scan, review DTCs/Data Monitor, perform required tests or utilities.

Notes for VCXDiag Nano

• Use the latest VCX Manager; set Device->J2534 (Nissan)].
• If connection fails, switch sub mode, replug USB, and reselect VI/MI.

Platform support
Windows 7, Windows 8.1, Windows 10, Windows 11.
Tested on Windows 10 LTSC (2019); also verified on recent Windows 11 builds.

Minimum system requirements

• CPU: Dual-core 2.0 GHz or better
• RAM: 4 GB (8 GB recommended)
• Storage: 15–25 GB free
• Display: 1366×768 or higher
• USB 2.0+, Internet for online programming

---

Disclaimer
Information is compiled from public sources for educational purposes. Any files, if referenced, are hosted by third parties; our forum does not store or distribute software. Use only with vehicles you are authorized to service and follow the official EULA and local laws.