Brief changes vs 2.67.1.2​

• Maintenance release with no major new functions or coverage changes reported.
• Corrected DiagnosticComponent V224 for the CRB actuator (FQ482831) to fix previous diagnostic/exception errors.
• Minor internal stability and bug-fix updates; existing guided tests, parameter handling and aftertreatment functions remain as in 2.67.1.x.

What’s new in SDP3 v2.67.1.2

• Latest data set with broader coverage for recent P/G/R/S series and Euro VI variants.
• Updated ECU/CIU definitions (e.g., COO/COO8, EMS, BMS, GMS2, ICL, ELC, RET/GRS) and parameter catalogs.
• More guided tests, calibrations and checks for aftertreatment and chassis systems.
• Improved stability with VCI2/VCI3 communication and faster startup.
• Bug fixes and minor UX refinements across diagnostics and programming workflows.

Compatibility

• Interfaces: Scania VCI2 / VCI3 (official adapters).
• OS: Windows 7 / 8.1 / 10 / 11 (64-bit). Tested on Windows 10 LTSC (2019).
• Hardware: 4-core CPU, 8 GB RAM minimum (16 GB recommended), 25–40 GB free disk space.

Install / Update notes

1. Back up reports, logs, and any SOPS/vehicle files from your current 2.66.3.3 setup.
2. Perform a clean install of SDP3 v2.67.1.2 (recommended to avoid legacy leftovers).
3. Reboot, connect VCI2/VCI3 and run a communication test before connecting to a vehicle.
4. Whitelist the installation folder in security software if the installer or services are blocked.

Good practice

• Use a regulated power supply during any programming or parameter write.
• Save vehicle readouts before changes for rollback/reference.
• Follow OEM licensing/authorization requirements for online and protected functions.

---

Disclaimer: This update note summarizes publicly available information and is provided for educational/informational purposes only. Any files referenced are user-submitted and may be hosted by third parties, forum staff does not verify ownership or licensing. Use Scania software strictly within applicable laws and the rights holder’s terms.