New request Please help me with a stage 1 for BMW 435xd

Post #1

B Online now

bmwx

Watchlisted

Spain
Joined
21.11.2026
Messages
1
Reactions
0
Location
Spain
Vehicle / engine
BMW 435xd
Reading tool / method (if known)
Ktag master
Hello,
I am looking for a clean Stage 1+ (~385–395 HP / ~760–780 Nm) + Full EGR OFF including at idle (DPF ON) built strictly from my attached original file (read with Alientech KTAG Master, Plug-in 667, MICRO TC1797, 4,194,304 bytes).
Hardware upgrades installed on the car:
  • Wagner Tuning Competition Evo 2 Intercooler
  • xHP Flashtool installed on the ZF 8HP70 transmission (gearbox torque limiters raised)


  • Factory DPF still installed and active
Important calibration requirements:
  1. Please modify ONLY my attached SW 547776 (O_7ETN0-000036C7-001) original binary — do not substitute a file from another chassis (F10/F15/F30).
  2. Full EGR OFF (0% closed across all RPM/load including idle via hysteresis maps, EGR plug connected, air-mass plausibility 24CE00/290900 handled properly without altering the physical MAF sensor linearization curve) while keeping DPF 100% active and automatic DPF regeneration working normally.
  3. Please keep wideband Lambda (1) feedback active, stock idle fueling (~5.1 mg/stk) untouched, and stock throttle-body behavior so there is zero rich idle exhaust smell.
  4. Keep safe EGT limits (≤ 850°C pre-turbo) and safe Bosch CP4 rail pressure limits (≤ 2,100–2,150 bar).
Thank you!
 
Ratings and Reviews
Total ratings: 0
Activity
So far there's no one here