EGSFlash BMW Gearbox Flasher – 6HP/8HP Stock & Modified Full Flash BIN

Average.7r said:

I've been looking for a solution to my E66 760Li. Xhp themselves don't support the 760li stating that its EGS is different than any other 6hp transmission. Basically, nobody can flash it, so I'm stuck with a slow trans. You said you've tested nearly every 6hp, I'm guessing the 760 is one of the ones you havent?

Click to expand...

Hello. By “testing,” I meant the transmissions that are supported by xHP.

Also, you are not quite correct — it’s not only the E66 760Li that is unsupported. There are many transmission types that xHP does not support.

For €100, I can port xHP Stage 3 to your specific hardware version. However, you will first need to read out the original file from your transmission/TCU.

If everything looks good, please contact me via private message.

Can I read the flash and eeprom from my 8hp with this ? Cheers

Hello everyone. First of all, thank you for the APK; I managed to download it. But I have a question, please, if someone can help or guide me: why is the xHP EGS file 1024 KB while my original file, read with xprog3 on the mod bench, is 2048 KB? Why is there such a big difference? My vehicle is a 2008 BMW X5 e70 m57 6hp28x. Or can I write my original file, which is 2048 KB, directly via OBD? Thank you for your guidance.

Hi, i did a little mistake.
I installed the app on an Android phone and completed the registration process without any issues. However, when I tried to read from or write to my car's transmission system, I realized that my phone does not support OTG.
I tried installing the app on a second phone, but it requires manual activation. How should I proceed?

Bin said:

EGSFlash is an Android full flash tool for BMW transmission control units. It programs complete BIN files, including original stock firmware and compatible modified or tuned files

Click to expand...

Can i write file read with 6hp Quick flash?

Thank you!

I almost bricked a GKE211. When I flash it it shows error at the end, then I can't use winkfp to flash it anymore, shows uif missing, I also can't use egsflash to flash it as well. In the end I have to buy 6hp quickflash and flash the backed up tune read from EGSFLASH. if egsflash can only flash tune part instead of whole program and calibration I think it will be much safer